User's Guide

KTS-1GA User Guide (TX Only)
1
CIRCUIT BREAKER
1. If buoys are about to store in the place without sunlight over 30days, please be
sure to PLUG IN the circuit breaker first to prevent over-discharging which may
damage batteries.
2. Before you charge buoys under the sun or by Kato charger, please PULL OUT the
circuit breaker first.
POWER ON/OFF
1. POWER-ON: Place the magnet on the switch to make the LED indicators
flash quickly and wait for 3-5 seconds. When the power indicator shuts down,
remove the magnets from the cover. Then, POWER ON is done.
2. POWER-OFF: Under Power-On mode, place the magnet on the switch to
make the power indicator illuminate and wait for 3-5 seconds. When the power
indicator shuts down, remove the magnet from the cover. Then, POWER OFF is
done.
BUOY TRANSMISSION
POWER-ON: When KTS-1GA buoy is powered on, it will report its last position,
remaining battery voltage, temperature and UTC time to the receiver on the vessel
and switch to its 10-minute Report Mode at the same time.
PS: In general, it takes 30~90 seconds to reposition the KTS-1GA buoy. If the
KTS-1GA is idle for a long time, or if the distance between the last and the newest
positions is too far, it takes longer to reposition the KTS-1GA.
POWER INDICATOR
Red Red Red Orange
Orange Orange Green
Green
Green Green
Stop using the buoy.
Please charge the buoy. The buoy can operate normally.
PS: When the power indicator shows in red, please stop using the buoy, or the
rechargeable battery inside the buoy will be over discharged and get damaged.

Summary of content (2 pages)