Instructions

Intesis
TM
KNX – Mitsubishi Electric A.C.
User's manual r17.0 EN
© HMS Industrial Networks S.L.U. - All rights reserved
This information is subject to change without notice
URL https://www.intesis.com
15 / 32
Figure 4.8 Parameter detail
o If set to “no” all the parameters and communication objects for the Fan Speed will
not be shown.
o If set to “yes” all the parameters and communication objects (if enabled in the
parameters dialog) for the Fan Speed will be shown.
Important: Read the documentation of your indoor unit to check if Fan Speed control is
available.
4.3.2 Available fanspeeds in Indoor Unit
This parameter lets choose how many fan speeds are available in the indoor unit.
Figure 4.9 Parameter detail
Important: Read the documentation of your indoor unit to check how many fan speeds
are available.
4.3.3 Indoor unit has AUTO fan speed
This parameter lets choose if the indoor unit has Auto Fan Speed available or not.
Figure 4.10 Parameter detail
o If set to “no” all the parameters and communication objects for the Auto Fan Speed
will not be shown.
o If set to “yes” a new parameter will appear. Find more information on section 2.4.6
Enable “Fan Speed Manual/Auto” objects.
Figure 4.11 Parameter detail
Important: Read the documentation of your indoor unit to check if Auto Fan Speed is
available.
4.3.4 Enable use of +/- object for Fan Speed
This parameter shows/hides the Control_ Fan Speed +/- communication object which lets
increase/decrease the indoor unit fan speed by using two different datapoint types.