Instructions

Intesis
TM
KNX – Mitsubishi Electric A.C.
User's manual r17.0 EN
© HMS Industrial Networks S.L.U. - All rights reserved
This information is subject to change without notice
URL https://www.intesis.com
19 / 32
Figure 4.17 Parameter detail
o If set to “no” all the parameters and communication objects for the Auto Vanes U-D
will not be shown.
o If set to “yes” a new parameter will appear. Find more information on section
Enable “Vanes U-D Man/Auto” objects (for Control and Status).
Figure 4.18 Parameter detail
Important: Read the documentation of your indoor unit to check if Auto Vane Position
is available.
4.4.4 Enable “Vanes U-D Swing” objects (for Control and Status)
This parameter shows/hides the Control_ Vanes U-D Swing and Status_ Vanes U-D Swing
communication objects.
o If set to “no” the objects will not be shown.
o If set to “yes” the Control_ Vanes U-D Swing and Status_ Vanes U-D Swing objects
will appear.
• When a “1” value is sent to the Control_ communication object, Vanes Up-
Down will be in Auto mode, and the Status_ object will return this value.
• When a “0” value is sent to the Control_ communication object, Vanes Up-
Down will be in Manual mode and the first position will be enabled. The
Status_ object will return this value.
4.4.5 Enable use of +/- object for Vanes U-D
This parameter shows/hides the Control_ Vane Up-Down +/- communication object which
lets change the indoor unit vane position by using two different datapoint types.
o If set to “no” the object will not be shown.