Instructions

Intesis
TM
KNX – Mitsubishi Electric A.C.
User's manual r17.0 EN
© HMS Industrial Networks S.L.U. - All rights reserved
This information is subject to change without notice
URL https://www.intesis.com
22 / 32
o If set to “no” the communication object will not be shown.
o If set to “yes” the communication object will appear. This object lets change the
indoor unit vanes behavior but it uses a different data type. It is used to maintain
compatibility with old gateway models.
4.5 Temperature Configuration dialog
Figure 4.21 Default Temperature Configuration dialog
All the parameters in this section are related with the Temperature properties and
communication objects.
4.5.1 Enable use of +/- object for Setpoint Temp
This parameter shows/hides the Control_ Setpoint Temp +/- communication object which
lets change the indoor unit setpoint temperature by using two different datapoint types.
o If set to “no” the object will not be shown.
o If set to “yes” the Control_ Setpoint Temp +/- object and a new parameter will
appear.
Figure 4.22 Parameter detail