Instructions

Intesis
TM
KNX – IR Universal AC
User's manual r1.3 EN
© HMS Industrial Networks S.L.U. - All rights reserved
This information is subject to change without notice
URL https://www.intesis.com
11 / 46
Connection of the device: KNX and USB connection
To get access to the KNX or mini USB connector, remove the screw as seen in Figure 3.5.
Figure 3.5 Top lid release and KNX connection
3.3.1 KNX port connection
Intesis device needs to be connected directly through a KNX TP-1 bus.
Disconnect power of the KNX bus. Connect the INKNXUNI001I000 to the KNX TP-1 (EIB) bus using the KNX
standard connector (red/grey) of the INKNXUNI001I000, respect polarity.
Reconnect power of the KNX bus, and mains power of the AC unit.
3.3.2 USB port connection
Intesis device allows a USB connection via mini USB port for the IR remote parameters or application program
version download. Please, refer to 4 CONFIGURATION AND SETUP for further information.
Figure 3.8 USB port connector
Make sure the device is not connected to power (KNX or USB) during the connection of the USB port.
Setscrew
USB port