Instructions

Intesis
TM
KNX – IR Universal AC
User's manual r1.3 EN
© HMS Industrial Networks S.L.U. - All rights reserved
This information is subject to change without notice
URL https://www.intesis.com
12 / 46
Binary Input connection
Intesis INKNXUNI001I000 interface is equipped with Binary Inputs from factory. To use the built-in binary inputs
in all the IR KNX Controllers, a standard 3,5mm stereo jack connector is required.
Connections will be as in the image below.
Figure 3.7 Binary Input connection
Before proceeding, please check the technical specification of the binary input below:
Once you are sure your installation is compliant with the specifications, please check the presence sensor or
window contact you would like to use. Basically, sensors only need to be equipped with a potential free external
CHANNEL 1: PRESENCE DETECTOR
CHANNEL 2: WINDOW CONTACT
STEREO JACK
(3,5 mm)
BINARY INPUT
CONNECTOR
KNX INPUT
CONNECTOR
CHANNEL 1
COMMON
CHANNEL 2
Potential free binary input
Signal cable length: 5m unshielded, may be extended up to 20m with twisted
Compliant with the following standards:
IEC61000-4-2: level 4 – 15kV (air discharge) - 8kV (contact discharge)
MIL STD 883E-Method 3015-7: class 3B