Instructions

Intesis
TM
KNX – IR Universal AC
User's manual r1.3 EN
© HMS Industrial Networks S.L.U. - All rights reserved
This information is subject to change without notice
URL https://www.intesis.com
13 / 46
contact. No matter if the contact is NO (Normally Open) or NC (Normally closed) as you will be able to configure
the contact type (NO or NC) of your sensor in the settings of the Binary Input function (Go to Settings menu in
the Intesis WEB Site).
IMPORTANT NOTE: Please, note that INKNXUNI001I000 interface will only react if the contact of your sensor
is opened or closed. In the case of the presence sensor, the installer needs to decide the specific settings of
the presence sensor to be applied. Intesis will be not responsible of the incorrect settings or incorrect
installations.
Recommendation: In some presence sensors or window contacts it is possible to setup a delay time to the
external contact. As you will see in this manual, Intesis Settings allow the user to setup a timer before starting
with the configured actions. Anyway, we recommend to setup a certain delay time in your presence sensor or
window contact to prevent continuous contact changes in a very short period of time.