Instructions

Intesis

KNX – IR Universal AC

User's manual r1.3 EN

This information is subject to change without notice

URL https://www.intesis.com

15 / 46

5 ETS Parameters and Configuration

The Intesis INKNXUNI001I000 interface is configured through ETS. General KNX parameters, such as the

physical address, group addresses or DPTs can be configured as usual using the ETS interface. For the specific

AC unit configuration and IR communication, the use of the specific plugin included in the ETS database is

required.

ETS database for this device can be downloaded from:

https://www.intesis.com/products/ac-interfaces/knx-gateways/universal-knx-ir-is-ir-knx-1

Please consult the README.txt file, located inside the downloaded zip file, to find instructions on how to install

the database.

Once the database is imported, the plugin can be accessed when editing parameters. To get access to

parameters edition, click on the Parameter tab, located in the project screen, and then press the specific

parameter dialog.

Figure 5.1 ETS Project managing and plugin screen

Remember that before start using the Intesis interface along with the AC unit, you need to set up at least the

brand and type of you AC unit. Check section 5.1 for more information about it.

Important: Please, update the Catalogue before proceeding with the device configuration and

programming. The laptop where ETS is running shall have Internet connection to update the catalogue.