Instructions

Intesis

KNX – IR Universal AC

User's manual r1.3 EN

This information is subject to change without notice

URL https://www.intesis.com

26 / 46

5.5.4 Enable use of +/- obj for Vane Up-Down

This parameter shows/hides the Control_ Vane Up-Down +/- communication object which lets you change the

indoor unit vane position by using two different datapoint types.

o If set to “no” the object will not be shown.

o If set to “yes” the Control_ Vane Up-Down +/- object.

➢ DPT type for +/- Vane Up-Down obj

This parameter lets choose between the datapoints 0-Up / 1-Down [DPT_1.008] and 0-Decrease / 1-

Increase [DPT_1.007] for the Control_ Vane Up-Down +/- object.

➢ Rollover Vane at upper/lower limit

This parameter lets choose if roll-over will be enabled (“yes”) or disabled (“no”) for the Vane Up-Down

+/- object.

5.5.5 Enable use of Text object for Vane U-D

This parameter shows/hides the Status_ Vane Up-Down Text communication object.

o If set to “no” the object will not be shown.

o If set to “yes” the Status_ Vane Up-Down Text object will appear.

Left-Right vanes configuration dialog

All the parameters in this section are related with the Vane Up-Down properties and communication objects.

5.6.1 DPT object type for Vane Left-Right

With this parameter is possible to change de DPT for the Control_ Vane Left-Right and Status_ Vane Left-Right

byte-type communication objects. Datapoints Scaling (DPT_5.001) and Enumerated (DPT_5.010) can be

selected.

o When “Enumerated [DPT 5.010]” is selected, Control_ Vane Left-Right and Status_ Vane Left-Right

communication objects for this DPT will appear.

▪ Up / Increase

▪ Down / Decrease

Pos. 3

Pos. 1

Pos. 2

Only if Roll-over is enabled

Pos. 5

Pos. 4

SWING