Instructions

Intesis

KNX – IR Universal AC

User's manual r1.3 EN

This information is subject to change without notice

URL https://www.intesis.com

30 / 46

This parameter lets choose between the datapoints 0-Up / 1-Down [DPT_1.008] and 0-Decrease / 1-

Increase [DPT_1.007] for the Control_ Setpoint Temp +/- object.

5.7.2 Set Point - Enable limits on Control_ Setpoint obj

This parameter enables to define temperature limits for the Control_ Setpoint Temperature object.

o If set to “no” the setpoint temperature limits for the Control_ Setpoint Temperature object will be the

default: 16ºC for the lower limit and 32ºC for the upper limit.

o If set to “yes” it is possible to define temperature limits for the Control_ Setpoint Temperature object.

➢ Control_ Set Temp Lower limit (ºC)

This parameter lets to define the lower limit for the setpoint temperature.

➢ Control_ Set Temp Upper limit (ºC)

This parameter lets to define the upper limit for the setpoint temperature.

Important: If a setpoint temperature above the upper defined limit (or below the lower defined limit) is sent

through the Control_ Setpoint Temperature object, it will be ALWAYS applied the limit defined.

Important: When limits are enabled, any setpoint temperature sent to the AC (even through scenes, special

modes, etc.) will be limited.

5.7.3 Set Point - Periodic sending time

This parameter lets you change the interval of time (in seconds, from 0 to 255) at the end of which the AC

setpoint temperature is sent to the KNX bus. For a “0” value, the AC setpoint temperature will ONLY be sent

on change. The AC setpoint temperature is sent through the communication object Status_ AC Setpoint Temp.

5.7.4 Ambient - Transmission of “Status_ Intesis Ref Temp”

This parameter lets to you choose if the Intesis reference temperature will be sent “only cyclically”, “only on

change” or “cyclically and on change”. The Intesis reference temperature is sent through the communication

object Status_ Intesis Reference Temperature.

5.7.5 Ambient - Periodic sending time

This parameter will only be available for the “only cylically” and “cyclically and on change” options, and lets

you change the interval of time (in seconds, from 1 to 255) at the end of which the Intesis reference temperature

is sent to the KNX bus.

▪ Up / Increase

▪ Down / Decrease

…

16ºC

17ºC

32ºC

31ºC

(Upper limit)

(Lower limit)