Instructions

Intesis

KNX – IR Universal AC

User's manual r1.3 EN

This information is subject to change without notice

URL https://www.intesis.com

34 / 46

o If set to “no” the object will not be shown.

o If set to “yes” the Control_ Window Contact Input object will appear. If a “1” value is sent to this object,

and the indoor unit is already turned on, the switch-off timeout will begin. If a “0” value is sent to this

object, the switch-off timeout will stop.

➢ Input Object

This parameter lets you choose between the datapoints 0-Open / 1-Closed Window [DPT_1.009] and

0-Stop / 1-Start Timeout [DPT_1.010] for the Control_ Switch Off Timeout.

➢ Timeout (min)

This parameter lets you select how much time (in minutes) to wait before switching off the indoor unit.

➢ Reload last Value

If set to “no”, once the switch-off timeout is stopped, any value will be reloaded.

If set to “yes”, once the switch-off timeout is stopped, the last On/Off value sent will be reloaded.

• If a “1” value is sent to the Control_ Window Contact Input object after the timeout period, the

indoor unit will turn on.

• If a “0” value is sent to the Control_ Switch Off Timeout after the timeout period, no action will

be performed.

➢ Lock ON when Open

If set to “no”, On/Off commands while the window is open will be accepted.

• If a “1” value is sent to the Control_ Switch Off Timeout object the switch-off timeout period will

begin again.

• If a “0” value is sent to the Control_ Switch Off Timeout object, no action will be performed.

If set to “yes”, On/Off commands, while the window is open, will be saved (but not applied). These

commands will be used in the next parameter if set to “yes”.