Instructions

Intesis

INMBSDAI001R000

User’s Manual r3.8 EN

This information is subject to change without notice

URL https://www.intesis.com

13 / 25

This register always informs about the current temperature setpoint which is being used

by the indoor unit and it is also includes the temperature setpoint that will be shown by

an additional remote controller from Daikin connected to the indoor unit, if it is present on

the system.

This register will show the same value as AC unit temperature setpoint register

(register 23 – In Protocol address / register 24 – in PLC address) if no virtual temperature

is applied.

Moreover, notice that temperature’s values of all these four registers are expressed according to

the temperature´s format configured through its onboard DIP-Switches (See “4.3 DIP-switch

Configuration Interface”).

These following formats are possible:

• Celsius value: Value in Modbus register is the temperature value in Celsius (i.e. a

value “22” in the Modbus register must be interpreted as 22ºC)

• Decicelsius value: Value in Modbus register is the temperature value in decicelsius

(i.e. a value “220” in the Modbus register must be interpreted as 22.0ºC)

• Fahrenheit value: Value in Modbus register is the temperature value in Fahrenheit

(i.e. a value “72” in the Modbus register must be interpreted as 72ºF (~22ºC).