Instructions

Intesis

INMBSDAI001R000

User’s Manual r3.8 EN

This information is subject to change without notice

URL https://www.intesis.com

25 / 25

8. Annex 1: Master/Slave of Operation Mode

The Master/Slave of Operation mode only applies under the following conditions:

1. The AC system is VRV

2. The VRV system uses a Heat pump as outdoor unit

3. There more than one indoor unit in a unique system working at different modes

(Table 8.1)

If they are not matched the parameter is going to be ignored.

The Heat pump outdoor unit of a VRV system can only work in one mode (either Heat, Cool or

fan). The Master of mode is the indoor unit that defines which is the working mode of the outdoor

unit. If no unit has been chosen as the one that defines the working mode of outdoor unit, the

first indoor unit to be turned On is the one which is going to define and control the mode.

In a VRV system, there is only one device acting as Master of Mode. If more than one is configured

in this way, the system is not going to work properly. The configuration will be determined by the

Remote Controller of Daikin. The unit which controls the Operation mode must have installed a

Remote Controller.

When an INMBSDAI001R000 is configured as Master of Mode via the Remote Controller of its

indoor unit, it can control all the modes of the system. The Mode selection of the gateways

remaining and remote controllers installed in the indoor units remaining is going to be affected

by the one chosen as Master of Mode. These ones are going to acquire the Slave of mode

configuration, not being able to change to any mode selection out of the Table 8.1.

Master of Mode

Mode of operation (as Slave of mode of Operation)

Heat

Heat, Fan

Dry

Cool, Fan, Dry

Fan

Cool

Cool, Fan, Dry

Table 8.1 Master and Slave of Mode configuration