Instructions

Intesis
®
Modbus RTU – Fujitsu User Manual r1.3 EN
© HMS Industrial Networks S.L.U - All rights reserved
This information is subject to change without notice
URL https://www.intesis.com
12 / 21
DIP-switch Configuration Interface
All the configuration values on INMBSFGL001I000 can be written and read from Modbus interface. Otherwise, some
of them can also be setup from its on-board DIP-switch interface.
The device has DIP-switches SW1, SW2 and SW3 on the following locations:
*Consider OFF as
The following tables apply to the interface´s configuration through DIP-switches:
SW1 – AC configuration + Modbus baud rate
AC Configuration
Modbus Baud rate
SW1-P1…5
Description
SW1-P6..8
Description
Not used (default
value)
Low Power mode
(default value)
2400bps
Not used
High Performance
mode
4800bps
Not used (default value)
9600bps (Default
value)
Not used
19200bps
Not used (default value)
38400bps
Not used
57600bps
Not used (default value)
76800bps
Not used
115200bps
Table 4.1 SW1: AC Configuration + Modbus baud rate
SW1
B A SG
EIA 485
SW3
SW2
ON ON
ON
SW1
1 2 3
1 2 3 4 5 6 7 8
SW3
SW2
ON
ON
ON
ON
ON
1 2 3 4 5 6 7 8
AC Unit
L1 L2
AC Unit
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON
ON