Instructions

Intesis

INMBSMIT001I000

User’s Manual r2.4 EN

This information is subject to change without notice

URL https://www.intesis.com

5 / 19

1. Presentation

The INMBSMIT001I000 interfaces allow a complete and natural integration

of Mitsubishi Electric air conditioners into Modbus RTU (EIA-485)

networks.

Compatible with all models of Domestic and Mr.Slim line. Check the

section 5 for more information.

Reduced dimensions. 93 x 53 x 58 mm // 3.7” x 2.1” x 2.3”

• Quick and easy installation.

Mountable on DIN rail, wall, or even inside the indoor unit on some models of AC.

• External power not required.

• Direct connection to Modbus RTU (EIA-485) networks. Up to 63 INMBSMIT001I000 devices

can be connected on the same network.

INMBSMIT001I000 is a Modbus slave device.

• Direct connection to the AC indoor unit. Up to 1 AC indoor units can be connected to

INMBSMIT001I000. The cable for this connection is also supplied.

• Configuration from both on-board DIP-switches and Modbus RTU.

• Total Control and Supervision.

• Real states of the AC unit's internal variables.

• Allows simultaneous use of the AC’s remote controls and Modbus RTU.

* Up to 63 Intesis devices can be installed in the same Modbus RTU bus. However, the installation of Modbus Repeaters may be

required.

• SCADA

• PLC

• DDC

• BMS

• HMI

• Controller

• etc

Up to 63

AC indoor

units*

Modbus RTU

EIA-485 network

Modbus RTU

Master

device

INMBSMIT001I000