User's Manual

(303PO) MODEL SM24101 SWIMMING MACHINE ENGLISH 7.5” X 10.3” PANTONE 295U 02/21/2017
303
PO
SAVE THESE INSTRUCTIONS
English
Page 18
TROUBLESHOOTING GUIDE
LED PANEL
CODE
PROBLEM SOLUTION
E
●
The maximum operating time
(90minutes)hasnishedunderthe
same set mode.
●
It's normal. Turn off and unplug the unit.
ThenplugtheRCD/GFCIbackand
restartallbackagain.
C
●
 Lowwaterlevel.
●
swim-trainer unit is not fully immersed
in the water.
●
Remote control is in an emergency cut
off situation.
●
Household voltage is too low.
●
Fill the pool with water up to correct water
level (see pool owner‘s manual).
●
 Makesurethedeviceisunderthewater.
●
It‘s normal. Turn off the transformer for 1
minute, then plug in.
●
 Checkthevoltageiswithintherange
stated on the device housing.
H
●
Household voltage is too heigh
.
●
Clogged motor impeller
●
Checkthevoltageiswithintherange
stated on the device housing
●
 Turnoffthepower,checkandcleanthe
motor impeller
L
●
Water temperature is around
35°C (95°F)
●
Turn off and unplug the unit. When the
waterhascooleddown,plugtheRCD/
GFCIbackandrestartalloveragain.
P
●
Operating time is too long
●
Water temperature is around
35°C (95°F)
●
Turn off and unplug the unit, after 30
minuteslaterplugtheRCD/GFCIback
and restart all over again.
●
Turn off and unplug the unit. When the
waterhascooleddown,plugtheRCD/
GFCIbackandrestartalloveragain.