User's Manual

(303PO) MODEL SM24101 SWIMMING MACHINE ENGLISH 7.5” X 10.3” PANTONE 295U 02/21/2017
303
PO
SAVE THESE INSTRUCTIONS
English
Page 19
TROUBLESHOOTING GUIDE (continued)
PROBLEM CAUSE SOLUTION
Mountingbracket
can‘t be assembled
with the in ground
pool
●
The ground is not concrete, i.e., it is
asphalt, lawn or earth.
●
The screws are not fully inserted in the
drill holes.
●
Assemblythemountingbracket
on the cement ground.
●
Checkandtightenthescrews
securely.
swim-trainer unit is
not horizontal with
the water surface
●
 Thesupportbracketisnotopened.
●
Adjust the support nuts on the
swim-trainer unit.
●
Open and adjust the support
bracket.See“SetupInstructions”.
●
Adjust the support nuts on the
swim-trainer unit.
No output from the
transformer
●
swim-trainer unit will hibernate if no
operating more than 1 hour.
●
Thetransformerfusebroken.
●
Motor too hot and overload protection is
shut off.
●
Turn off the transformer, waiting 2
minutes then turn on agin.
●
Replace the transformer fuse.
●
Letthemotorcooldownand
restart again.
NoLEDdisplay
●
The transformer is unplugged or off.
●
The transformer is not connected with
swim-trainer unit.
●
Display panel cord is loose.
●
Display panel failure.
●
Emergency stop lanyard is put wrong
place.
●
Ensure the transformer is plugged
and switched on.
●
Connect the transformer with
swim-trainer unit.
●
Ensure that the display cord is
pluggedrmlyintothecellhousing
receptacle.
●
Contact Intex Service Center.
●
Put the emergency stop lanyard
on correct place. See “Setup
Instructions”.
Abnormaldisplay/
buttonsnotworking
●
Display panel cord is loose.
●
Display panel failure.
●
Ensure the display cable is
pluggedrmlyintothedisplay
panel receptacle .
●
Contact Intex Service Center.
Toonoisy/Jetwater
isweakorshaking
●
Swim-trainer unit is not fully immersed in
the water.
●
The motor impeller isbroken.
●
swim-trainer unit components
not securely connected or in place.
●
Makesurethedeviceisunder
the water.
●
Turn off and replace the motor
impeller.
●
Checkallcomponents,especially
thesupportbracket.See “Setup
Instructions”.
Remote Control out
of control
●
The battery is on low power.
●
Replace the remote control
battery.
See“OperatingInstallations”