Operation Manual

264

S AVE THESE INSTRUCTIONS

(264PO) SPA (JET + BUBBLE) ENGLISH 7.5” X 10.3” PANTONE 295U 10/19/2016

English

MAINTENANCE

IMPORTANT

Unplug the power cord before cleaning the system. Cover the water inlet and outlet with

the plugs to prevent water spillage. After completing all maintenance tasks, you must

plug the power cord back in and remove the plugs.

Electrolytic Cell Cleaning

The electrolytic cell has a self cleaning function incorporated into the electronic control's programming. In

most cases this self cleaning action will keep the cell working at optimum efﬁ ciency. In some regions, the

SPA water is hard (high mineral content) which varies depending on the local water condition, this would

cause deposits on the titanium plate and affect the sanitizing efﬁ ciency, so the cell may require periodic

manual cleaning. To maintain maximum performance, we recommend that you open and visually inspect

the electrolytic cell every two weeks for SPA water (Calcium hardness < 100 ppm) or weekly for SPA water

(Calcium hardness > 350 ppm).

The following steps provide instructions on how to clean the cell.

Inspection and cleaning:

Turn off the spa and unplug the power cord from the electrical socket.

Unscrew the ﬁ lter cartridge assembly from the spa tub wall, and use the included plugs

(15 & 23)

cover the water inlet and outlet ﬁ ttings from inside of the spa tub to prevent water from ﬂ owing out.

Disconnect the spa control unit from the spa tub and use the included plugs to cover the water inlet

and outlet ﬁ ttings from outside of the spa tub to prevent water from ﬂ owing out.

Remove the four screws from the transparent cover using a Phillips screwdriver (not included) and

remove the cover from the spa control unit.

Page 19

Maintenance of Spa Water and Cartridge

Protect all the spa occupants from possible water-related illnesses by keeping the spa water clean and

sanitized. Always practice good hygiene. To ensure proper spa water quality follow these procedures:

Inspect and clean the ﬁ lter cartridge once a week, and change the ﬁ lter cartridge as needed.

Unscrew the cartridge housing assembly from the spa tub wall

and remove the cartridge

(see drawing 11)

Use a garden hose to rinse off the cartridge. If the cartridge

remains soiled and discolored it should be replaced. Keep spare

cartridges on hand.

Reinstall the clean cartridge back into the cartridge housing and

replace the cartridge housing assembly back onto the spa tub wall.

Change the spa water every 2~3 months, or it becomes cloudy and

proper water chemistry does not clear it up. See “Spa Tub Drainage”

and “Spa Tub Cleaning” sections for details.

Use spa chemicals to maintain proper water chemistry. Spa damage

resulting from misuse of chemicals and mismanagement of spa water

is not covered by the warranty.

All occupants must shower before entering the spa.