User Guide
(260PO) MODEL ECO7110&8110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 07/07/2014
260
PO
SAVE THESE INSTRUCTIONS
English
Page 19
OPERATION INSTRUCTIONS (continued)
6
.
Boost cycle
•
Firsttimeinstallation,pressandhold“BOOST”
button for 5 seconds until the indicator lights up and the
LED display “80”. This indicates that the saltwater
system has started E.C.O. and more chlorine sanitizer
production.Youcanpressandholdthe“BOOST”buttonfor
another 5 seconds until the indicator is off, which will cancel
theBoostcycle.
•
The boost operating hours is 8 times the amount of time programmed into the system, i.e. if
your saltwater system operating time is 2 hours, the boost procedure will run 8 x 2 = 16 hours.
After boost procedure has been completed, the system will automatically switch to the
normal working mode.
•
Once the boost is operating, check whether the filter pump operating hours have been
setproperly.Forexample,theboostoperatingtimeis8hours,thefilterpumpshouldbe
set to run for 8 hours at least. Increase the filter pump operating time if necessary.
Note:
If an Intex filter pump is attached to the system, set the pump switch to on “I”
position.
•
Afteraheavyrainorifthepoolisdirty,pressthe“BOOST”buttontoshockthepool
again.
7
.
Stand-by/power saving mode:
•
When the cycle ends, the green “SLEEP” indicator on the
control panel lights up and the LED display flashes “93”.
ThesystemisnowinStand-Bymode.Afterawhile,it
shuts down and sets itself in a Power Saving mode. The
system will automatically turn itself back on in 24 hours,
starting its daily cycle of chlorine production.
•
The “SLEEP” indicator stays on, while the system is in the
Power Saving mode. The LED display however, goes blank
after5minutes.Pressanybutton(or)toviewthelast
LED code.