Operation Manual
SAVE THESE INSTRUCTIONS
Page 2
(249PO) MODEL ECO7111 Cartridge Filter Pump & Saltwater System with E.C.O. ENGLISH 7.5” X 10.3” PANTONE 295U 05/25/2016
English
249
PO
S AVE THESE INSTRUCTIONS
English
Page 27
TROUBLESHOOTING GUIDE (continued)
1
. Circulation line is blocked.
2
. Incorrect inlet and outlet hose direction.
3
. Scale on the flow sensor.
4
. Flow sensor cord is loose.
5
. Inner timer confliction between filter
pump and saltwater system.
6
. Flow sensor failure.
1
. Dirt or scale on titanium plates.
2
.Lowsaltlevel/Nosalt.
3
. Electrolytic cell cord is loose.
4
. Possible electrolytic cell failure.
1
. High salt level.
1
. Display and all lights are off - the
system does not power up.
•
If your unit has plunger valves, ensure that
they are open.
•
Clear your filter cartridge and cell from debris
and dirt. See “Maintenance”.
•
Release all trapped air in the circulation line.
See the filter pump manual.
•
Check the direction of the inlet and the outlet
hose. Reverse the hoses if necessary. See
“Set Up Instructions”.
•
Clean the flow sensor, paying special attention
to the hinge. See “Maintenance”.
•
Plug the flow sensor firmly into the flow sensor
receptacle.
•
Reset both timers on the filter pump and
saltwater system.See “Boost Cycle”.
•
Contact Intex Service Center.
•
Remove the electrolytic cell for inspection.
Clean it if necessary. See “Maintenance”.
•
Addsalt.See“Salt&PoolWater
Volumes”.
•
Ensure that the cell cord is plugged firmly into
the cell housing receptacle.
•
Contact Intex Service Center. Replace the cell
if needed.
•
Partially drain the pool and refill it with fresh
water.See“Salt&PoolWaterVolumes”.
•
Household voltage is too high or too low
(+20%).Checkthevoltageiswithintherange
stated on the device housing.
•
Contact Intex Service Center.
LED PANEL
CODE
PROBLEM
SOLUTION
LEDPanelCodeFlash&AlarmOn(
NOTE
: Always turn off the power before cleaning and servicing).
IMPORTANT
If you continue to experience difficulty, please contact our Consumer Service Department for
assistance. See separate “Authorized Service Centers” sheet.