Manual

(155PO) POOL LIGHT ENGLISH 7.5” X 9.25” PANTONE 295U 06/08/2012
155
PO
SAVE THESE INSTRUCTIONS
Page 6
English
SETUP INSTRUCTIONS & STORAGE
SETUP INSTRUCTIONS (continued)
Installation on Intex Sequoia Spirit Wood-Grain Pools:
Unscrew the bolts from the section where the LED pool-wall light will be installed,
and remove the clamp covers, the top board and the side boards. Refer to the
Wood-Grain Pool owner’s manual for details. For better installation, it is
recommended to remove at least 3 side board panels. Follow above setup
instructions 1 to 4.
LONG TERM STORAGE
In areas where freezing temperatures occur, there is risk of ice damage to
the product. It is recommended to remove, clean and store the product in
a safe place when temperature drops below 0 degrees Celsius (32 degrees
Fahrenheit).
1. Unplug the power cord from the electrical socket.
2. Remove the transmitter (2)fromtheoutsideofthepoolwallrst,thepool
light (1)unitwillautomaticallyoattothesurfaceforeasyretrieval,thenremove
the pool light from the water.
IMPORTANT: To prevent damage to the transmitter from falling to the
ground, always remove the transmitter rst before removing the pool light
unit.
3. If deposits or debris are seen inside the holes of the pool light, use a garden
 hosetoushthemout.Donotscrapethepool-walllightorusebrushtocleanit.
4. Thoroughly air-dry all components before storage.
5. Store the product and accessories in a dry, temperature controlled location
between 32 degrees Fahrenheit (0 degrees Celsius) and 104 degrees
Fahrenheit (40 degrees Celsius).
6. The original packaging can be used for storage.
4 5