User guide

(155PO) POOL LIGHT ENGLISH 7.5” X 9.25” PANTONE 295U 04/28/2013
English
SAVE THESE INSTRUCTIONS
155
PO
Page 6
SETUP INSTRUCTIONS (continued)
Installation on Intex Sequoia Spirit Wood-Grain Pools:
Unscrew the bolts from the section where the LED pool-wall light will be installed, and remove the
clamp covers, the top board and the side boards. Refer to the Wood-Grain Pool owner’s manua
for details. For better installation, it is recommended to remove at least 3 side board panels. Follow
above setup instructions 1 to 4.
LONG TERM STORAGE
In areas where freezing temperatures occur, there is risk of ice damage to the product. It
is recommended to remove, clean and store the product in a safe place when temperature
drops below 0 degrees Celsius (32 degrees Fahrenheit).
1. Unplug the power cord from the electrical socket.
2. Remove the transmitter (2)fromtheoutsideofthepoolwallrst,thepoollight(1) unit will
 automaticallyoattothesurfaceforeasyretrieval,thenremovethepoollightfromthewater.
IMPORTANT: To prevent damage to the transmitter from falling to the ground, always
remove the transmitter rst before removing the pool light unit.
3. Ifdepositsordebrisareseeninsidetheholesofthepoollight,useagardenhosetoushthem
out. Do not scrape the pool-wall light or use brush to clean it.
4. Thoroughly air-dry all components before storage.
5. Store the product and accessories in a dry, temperature controlled location between 32 degrees
Fahrenheit (0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius).
6. The original packaging can be used for storage.
4 5