User guide

(155PO) POOL LIGHT ENGLISH 7.5” X 9.25” PANTONE 295U 04/28/2013
English
SAVE THESE INSTRUCTIONS
155
PO
Page 7
IMPORTANT
If you continue to experience difculty, please contact our Consumer Service Department for
assistance. See separate “Authorized Service Centers” sheet.
• Rearrangetheorientationofthepoollight
and the transmitter. See “setup instructions”.
• ContactIntexServiceCenter.
• ContactIntexServiceCenter.
• ContactIntexServiceCenter.
DIFFICULT TO ALIGN
THE POOL LIGHT AND
THE TRANSMITTER
THE LED
POOL-WALL LIGHT
DOES NOT LIGHT UP
• Wrongorientation,magneticpoles
are not aligned correctly.
• Thepowercordisloose.
• Wrongorientationandalignment
between the pool light and the
transmitter.
• Waterinsidepoollightunit.
•Possibletransmitterortransformer
failure.
•Waterinsidethepoollightunit.
PROBLEM CAUSE SOLUTION
TROUBLE SHOOTING GUIDE
Operation is subject to the following two conditions: (1) this device may not causeinterference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the device.
Changesormodicationsnotexpresslyapprovedbythepartyresponsibleforcompliancecouldvoidtheuser’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Plugthecordrmlyintotheelectricaloutlet.
• Tightentheintermediateconnection
between the transmitter and the transformer.
• TheGFCIistripped.
• Rearrangetheorientationofthepoollight
and the transmitter. See “setup instructions”.
THE POOL LIGHT UNIT
DOES NOT FLOAT