User's Manual

You can configure the Wi-Fi Repeater Mode by connecting it with your
computer/laptop with enclosed RJ45 cable or wirelessly.
A. Configure the Wi-Fi Repeater Mode wirelessly.
A1. The mode selector must be
set to the "AP/Repeater" position
for Repeater Mode. Plug the
AP/Router into a wall socket.
A2.Click on the network icon (
or
) on the right bottom of your
desktop. You will find the signal
from the Wireless-AC or
Wireless-N(2.4G). Click on
Connect’ then wait for a few
seconds.
A3.Open web browser and
type http://192.168.10.1 or
http://ap.setup in the browser
address box. This number is
the default IP address for this
device.
Note: Please check whether the AP/Router accord with factory default
settings once you can’t entered http://192.168.10.1. If you are still not sure
what reasons, you can reset the AP/Router, just need to press the reset
button for 8 seconds, then try again.