User's Manual

Chapter 2. Prior to Installation
24
Site Prerequisites
Introduction
This paragraph describes all the prerequisites that must be considered prior
to installing the equipment.
Site survey
Site survey should be done before start the installation taking in
consideration the following:
Premises information
• Site details (address, contact persons, GPS and/or map co-ordinates, etc.)
• Site access and storage information (means of transport, equipment
storage and lifting information, etc.)
• Site location maps
Network planning
• Site Coordinates
• LOS verification
• Rooftop information (height, status, access, dimensions, layout, etc.)
• Information about pre-existing indoor/ outdoor equipment
• Available mounting space (on the buildings’ roofs) to reserve for the
installation of the outdoor equipment
Site-specific information
• Mechanical specifications of masts/ towers (type, dimensions/ diameter,
material, exterior finishing, etc.)
• Location of appropriate grounding points (bar or terminals).
• Location of appropriate power supply distribution points.
• Location of cable conduits available for routing the cables.
• Location of the network port distributors.
• Total length of the cables required.
The site survey report must be agreed and signed between all
involved parties.
Continued on next page