Installation Instructions

WiBAS / WiBAS G5 Terminal Stations
Installation & Cabling Manual - Edition 2.1
215
Power, Continued
Procedure
How to terminate the 2 x 1 mm
2
or 2 x 2.5 mm
2
DC power supply cable to
POE-HP-OD67-DC connector, proceed as follows:
Step
Action
1
Perform the following:
 Strip approx. 10 mm from the cable’s outer sheath (A).
 Strip approx. 4 mm from each wire insulation (B).
 Pass the cable through the parts of gland (C).
2
Solder the 2 pins to the connector taking in consideration the
following polarity concern:
Continued on next page