Installation Instructions

WiBAS / WiBAS G5 Terminal Stations
Installation & Cabling Manual - Edition 2.1
159
Grounding Cable, Continued
Procedure for
WiBAS G5
Connect+
How to install the grounding cable to radio unit (WG5-CONN-PLUS-LB-
UB), proceed as follows:
Step
Action
1
Use the tool (adjustable torque wrench with hexagon female
bit) to remove the pre-installed M5 grounding nut.
2
Perform the following actions:
 Install the cable, as shown below.
 Use the tool (adjustable torque wrench with hexagon female
bit) to tighten the screw.
Do not over tighten the M5 nut. Adjust the tool for
applying maximum tightening torque 4.2 Nm.
DO NOT forget to install the other end of the grounding
cable to grounding bar.
End of procedure.
Continued on next page