Installation Instructions

4. Installation Procedures
164
ETH Cable, Continued
Procedure,
continued
Step
Action
2
Pass the cable through the parts of gland, as shown below.
The seal shown below is split-type for easy installation and
removal.
Insert and install the RJ-45 jack of the cable into the mating
receptacle radio unit. Listen for a “click” when inserting.
This verifies that the jack has been inserted properly.
3
Use the U-wrench to tighten.
Do not over tighten. Adjust the tool for applying
maximum tightening torque 5 Nm.
Continued on next page