Installation Instructions

Appendix A - Installing Power Injectors
184
PONE-OD67-AC, Continued
Procedure
How to install the PONE-OD67-AC onto the pole or wall, proceed as
follows:
Step
Action
1
For pole installation follow this step. For wall installation go to
last step.
Perform the following actions:
 Attach the plate onto rear side of PONE (A), as shown below.
 Install lock washer and screw. Then use the cross headed
screwdriver to fully tighten (B).
 Pass the hose clamp through the plate holes (C).
 Install the PONE onto pole. Use the tool with M5 deep socket
to tighten (D).
Do not over tighten. Adjust the tool for max tightening
torque 2 Nm.
 Use the wrench tool to remove the two sealing nuts (E). Then
remove the claw and seal.
Continued on next page