Manualshelf

Installation Instructions

ManualsBrandsINTRACOM ManualsElectronicsPtMP/PtP Gigabit Base Station Radio 27-29 GHz
11121314151617181920
4. Installation Procedures
178
Grounding Cable, Continued
Procedure for
WiBAS G5
micro-BS /
evo-BS
How to install the grounding cable to WiBAS
TM
G5 micro-BS / evo-BS radio
unit, proceed as follows:
Step
Action
1
If the terminal lug is installed then follow this step. If the
terminal lug is not installed then follow step 2.
Use the tool to remove the pre-installed M5 grounding terminal.
2
Perform the following actions:
Install the cable, as shown below.
Use the tool with M5 hexagon female bit to fully tighten the
screw.
Do not over tighten the M5 nut. Adjust the tool for
applying maximum tightening torque 4.2 Nm.
DO NOT forget to install the other end of the grounding
cable to grounding bar.
End of procedure.
Continued on next page