Installation Instructions

4. Installation Procedures

182

ETH Cable, Continued

Procedure for

WiBAS OSDR-

HUB, continued

Step

Action

Plug the RJ-45 jack into the GbE2 or FE port of the WiBAS

OSDR.

Listen for a “click” when inserting. This verifies that the

jack has been inserted properly.

Perform the following actions:

 Use the U-wrench to screw the body into the radio thread

(A).

Do not over tighten. Adjust the tool for applying maximum

tightening torque 7 Nm.

 Insert claw into the body (B) taking into account the caution.

Align the designated points. Misaligning of parts will

cause damage.

Continued on next page