Installation Instructions

4. Installation Procedures
188
ETH Cable, Continued
Procedure for
WiBAS G5
dual-BS
How to install the ETH cable to WiBAS
TM
G5 dual-BS, proceed as follows:
Step
Action
1
Remove the metalic protective cap from GbE#1 receptacle, as
shown below:
2
Disassemble the ETH-HOOD-GX parts and remove the plastic
in the middle of the seal, as shown below:
3
Pass the cable through the parts of gland, as shown below.
The seal shown below is split-type for easy installation
and removal.
Continued on next page