Installation Instructions

WiBAS / WiBAS G5 Base Stations
Installation & Cabling Manual - Edition 3.2
189
ETH Cable, Continued
Procedure for
WiBAS G5
dual-BS,
continued
Step
Action
4
Insert and install the RJ-45 jack of the cable into the mating
receptacle of the radio unit.
Listen for a “click” when inserting. This verifies that
the jack has been inserted properly.
5
Install the body (M20 thread).
Do not over tighten. Adjust the tool for max tightening
torque 5 Nm.
Insert claw into the body (M20 thread).
Align the designated points. Misaligning of parts will
cause damage.
Continued on next page