User Manual
Table Of Contents
- LIVE SYSTEM
- STARTUP MANUAL
- INTENTIONALLY BLANK
- TABLE OF CONTENTS
- CUSTOMER SUPPORT
- Bin-Sense LIVE CERTIFICATIONS
- MANUFACTURER’S WARRANTY
- SAFETY
- OVERVIEW
- SYSTEM SET UP
- CREATING ASSOCIATIONS
- MASTER UNIT FIRST CALL-IN
- 2. Once the Master unit diagnostic LED stops blinking, press and hold the scan button for six seconds. The LED should turn green and then after a few seconds turn pale blue and then go back to green.
- 3. The modem status LED will begin blinking. The modem status LED and diagnostic LED will both turn off once the call-in is complete.
- 4. Disconnect the power and restart the Master unit into normal mode to begin connecting to Remote units.
- INTENTIONALLY BLANK
- OPERATION
- MASTER UNIT OPERATION
- REMOTE UNIT OPERATION
- MASTER UNIT MODES
- Normal Mode
- Listener Mode
- FORCING A UNIT TO START IN NORMAL MODE
- 2. With the power off, press and hold the scan button.
- 3. Continue to hold the scan button and reconnect the Master unit battery. The diagnostic LED will light up solid green.
- 4. Wait five seconds, then release the scan button. The diagnostic LED will begin flashing rapid green.
- 5. Press and release the scan button. The Master unit will enter normal mode.
- 6. Reconnect the solar panels.
- MASTER UNIT SCANNING
- STARTING AND CONNECTING MASTER AND REMOTE UNITS
- OPERATION
- INTENTIONALLY BLANK
- STARTUP MANUAL
www.binsense.com March 2022 Version 1.0 Page 11
Remote units, it will connect to any new Remote units powered on in the last 68 minutes. It is important to make
sure the Master unit has been sent scan commands to keep looking for new Remote units. This method works
well on large sites that require numerous man-hours to install the Bin-Sense Live system as each Master unit
and Remote unit must only be handled once during the installation process, and Remote units connect to the
Master unit within 68 minutes of being powered on.