User Manual
Table Of Contents
- LIVE SYSTEM
- STARTUP MANUAL
- INTENTIONALLY BLANK
- TABLE OF CONTENTS
- CUSTOMER SUPPORT
- Bin-Sense LIVE CERTIFICATIONS
- MANUFACTURER’S WARRANTY
- SAFETY
- OVERVIEW
- SYSTEM SET UP
- CREATING ASSOCIATIONS
- MASTER UNIT FIRST CALL-IN
- 2. Once the Master unit diagnostic LED stops blinking, press and hold the scan button for six seconds. The LED should turn green and then after a few seconds turn pale blue and then go back to green.
- 3. The modem status LED will begin blinking. The modem status LED and diagnostic LED will both turn off once the call-in is complete.
- 4. Disconnect the power and restart the Master unit into normal mode to begin connecting to Remote units.
- INTENTIONALLY BLANK
- OPERATION
- MASTER UNIT OPERATION
- REMOTE UNIT OPERATION
- MASTER UNIT MODES
- Normal Mode
- Listener Mode
- FORCING A UNIT TO START IN NORMAL MODE
- 2. With the power off, press and hold the scan button.
- 3. Continue to hold the scan button and reconnect the Master unit battery. The diagnostic LED will light up solid green.
- 4. Wait five seconds, then release the scan button. The diagnostic LED will begin flashing rapid green.
- 5. Press and release the scan button. The Master unit will enter normal mode.
- 6. Reconnect the solar panels.
- MASTER UNIT SCANNING
- STARTING AND CONNECTING MASTER AND REMOTE UNITS
- OPERATION
- INTENTIONALLY BLANK
- STARTUP MANUAL
