User's Manual
Table Of Contents
- MASTER UNIT
- INTENTIONALLY BLANK
- Table OF CONTENTS
- CUSTOMER SUPPORT
- Bin-Sense MASTER CERTIFICATIONS
- MANUFACTURER’S WARRANTY
- SAFETY
- OVERVIEW
- PACKAGE CONTENTS
- MASTER UNIT OVERVIEW
- INSIDE THE MASTER UNIT
- INSTALLATION
- INSTALLATION TIPS
- MASTER UNIT INSTALLATION
- 1. Place the Master unit on the top of the bin with the lid latches and link cables pointing towards the ground. Place the unit where it is easily accessible for future service and maintenance. The magnetic feet will hold the unit in place on the roo...
- 2. Place the external Remote antenna so that its signal will reach the most Remote units possible. Whenever possible, place the antenna so that it has clear line-of-sight to remote units
- 3. Mount the two solar panels side-by-side on the bin facing the direction of maximum sunlight (face south in the northern hemisphere, face north in the southern hemisphere).
- 4. Place the Master unit battery on the roof of the bin close enough to the master unit that the battery cable will reach the Master unit power cable.
- 5. Connect the Master unit sensor link cable to all the sensing cables and to any other Bin-Sense accessories (e.g. Fan Controllers). You’ll need to use a terminal box or splitter to connect more than one device to the sensor link cable.
- 6. Connect the Master unit power cable to the Master unit battery.
- 7. Connect the Master unit solar panel connections to both solar panels. Both solar panels connections are the same and can be connected to either solar panel.
- 8. Refer to the Bin-Sense Live Startup Manual for further instruction on how to get Bin-Sense Live system up and running.
- CONNECTING TO REMOTE UNITS
- INTENTIONALLY BLANK
Page 4 March 2022 Version 1.0 www.binsense.com
BIN-SENSE MASTER CERTIFICATIONS
FCC ID: 2AUTY-106103MU-V06
Contains FCC ID: XPY1EIQ24NN; IC: 8595A-1EIQ24NN
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly Approved by IntraGrain Technologies Inc. could void the user’s
authority to operate the equipment.
CAUTION: This equipment has been tested and found to comply with the limits for a class a digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
WARNING: RADIO-FREQUENCY RADIATION EXPOSURE RISK. THIS EQUIPMENT COMPLIES WITH
RADIATION EXPOSURE LIMITS PRESCRIBED FOR AN UNCONTROLLED ENVIRONMENT FOR FIXED
AND MOBILE USE CONDITIONS. THIS EQUIPMENT SHOULD BE INSTALLED AND OPERATED WITH A
MINIMUM DISTANCE OF 20 CM BETWEEN THE RADIATOR AND THE BODY OF THE USER OR NEARBY
PERSONS. THIS TRANSMITTER MUST NOT BE CO-LOCATED OR OPERATING IN CONJUNCTION WITH
ANY OTHER ANTENNA OR TRANSMITTER EXCEPT AS AUTHORIZED IN THE CERTIFICATION OF THE
PRODUCT.