User's Manual
Table Of Contents
- SOLO LTE-M
- SOLO 4G/3G (SK)
- INTENTIONALLY BLANK
- INTENTIONALLY BLANK
- CUSTOMER SUPPORT
- SOLO CERTIFICATIONS
- MANUFACTURER’S WARRANTY
- SAFETY
- OVERVIEW
- INSTALLATION
- INSTALLATION TIPS
- SETTING UP THE mobile APP
- 1. Create an account or log in on the Bin-Sense mobile app.
- 2. Navigate to the site where you want to add the Solo unit. If required, create a new site (i.e. bin yard) by tapping the + button in the top right corner and then selecting “Create Site”.
- 3. Once on the correct site, tap the + button in the top right corner and then tap “Add Solo Unit”.
- 4. Follow the step-by-step instructions to finish adding the device to a bin on the app.
- SOLO UNIT INSTALLATION
- 1. Place the Solo unit on the bin with the antenna fin end of the enclosure closest to the ground. The sensor link cable should point towards the ground to prevent water from running towards the enclosure. The magnetic feet will hold the unit in plac...
- 2. Connect the sensor link cable to the sensing cable(s) installed in the bin. A terminal box or splitter is required to connect more than one sensing cable to the sensor link cable.
- 3. Open the four latch clips and remove the lid from the Solo unit.
- 4. Remove the “Remove before use” tab(s) from the battery clip(s). Solo LTE-M has one battery tab, Solo 4G/ 3G (SK) has two battery tabs.
- 5. Watch the status LED and verify it has turned solid green to confirm the Solo unit is connected to a cell tower and Bin-Sense servers. See the LED diagnostics section for more details.
- 6. Use the mobile app to verify that the Solo unit is properly sending data to the Bin-Sense App and that all the connected cables are detected properly.
- Replacing Solo Unit Batteries
- DIAGNOSTICS
www.binsense.com May 2022 Version 1.0 Page 5
WHAT THIS WARRANTY DOES NOT COVER
This warranty does not cover normal wear of parts or any damage resulting from any of the following: negligent
use or misuse of the product; damage in transport, natural disaster, improper installation or use, improper
abuse or improper handling. This warranty is limited to only those manufacturing defects that were caused or
allowed by IntraGrain.
HOW TO OBTAIN WARRANTY SERVICE
Please contact the local dealer you purchased the product from. For additional support, please contact
IntraGrain Technologies Inc. at 1.833.570.7979 or visit www.intragrain.com
CONTACT US
For support questions, troubleshooting, or help with your Bin-Sense device, please contact your local dealer for
more information and assistance, or IntraGrain Technologies Inc. at support@intragrain.com or
1.833.570.7979.