User's Manual

i. LED status

1. ON/Off. Press and release button to Turn On/Off the LinkStream. LED

will light when on

2. Pairing mode. With the LinkStream On, Press and hold the button for 3

(??) seconds. LED will blink during pairing mode.

ii. Table capturing pairing scenarios – To pair LinkSteam accessory with a Lumen

1000 ear piece,

1. If Lumen 1000 is in standby mode goto step 2. Press and hold down

button for 5 seconds, the HA will enter Standby mode

2. Continue pressing the down button for 10 seconds. Afer 5 seconds, the

Lumen 1000 will wake up from Standby mode. Continue holding for the

remainder of the 10 seconds to enter pairing mode. (In pairing mode the

Lumen 1000 will generate a series of beeps that lasts for approximately 10

seconds.)

3. When Lumen 1000 enters pairing mode, press and hold button on

LinkStream for 5 seconds placing it into paitinr mode.

4. When pairing is complete the beeping in the Lumen 1000 will stop and

it will start receiving audio from the LinkStream device.

3. Using IPODA

a. Typical use scenarios (sketch with stickfigures)

b. Describe IPODA with PICTURE showing labels identifying components

flexstream Device Illustration

Device Description

1 flexstream Unit

2 Mic Cover

3 Mic Ports

4 Docking Connector