User's Manual

Troubleshooting Chapter 6
Page 108
6.4 Troubleshooting Guide
Condition Recommended Action
The MiroCam capsule
endoscope system
workstation fails to
power-up when the
I/O power switch is on.
1. Ensure that the MiroCam capsule endoscope
workstation main system is plugged into an
operational AC outlet in accordance with the input
specification rated on the side panel of the
workstation main system.
2. If the condition persists, contact IntroMedic Co.,
Ltd. or local representative.
The MiroCam capsule
endoscope system
receiver unit fails to
power-up when the
I/O power switch is on.
1. Recharge
battery of receiver unit.
2. Replace battery of receiver unit.
3. If the condition persists, contact IntroMedic Co.,
Ltd or local representative.
Capsule is not
blinking when taken
out of the case.
1. DO NOT use the
capsule. Use an alternate
capsule.
2. Contact IntroMedic Co., Ltd. for replacement of
capsule.
INI LED on receiver
unit is yellow, and
does not turn green
when held
appropriately by
patient.
1. Initialize receiver unit via MiroView™ software.
2. If the condition persists, contact IntroMedic Co.,
Ltd.
BAT LED, on receiver
unit is yellow.
1. Recharge battery of receiver unit.
2. Replace battery of receiver unit.
3. If the condition persists, contact IntroMedic Co.,
Ltd.