User's Manual

Chapter 5 Using MiroView™ RTV
5- 6
5.2.2 Starting MiroView™ RTV
 Switch on the UMPC.
 Click the
icon on the desktop to launch MiroView™ RTV.
 Connect the small side of the USB cable to the receiver.
 Connect the large side of the USB cable to the UMPC.
 Click the
button to start image display
 Click the
button to stop image display
 Click the
button to restart image display
 Click the
button on the top-right to close the MiroView™ RTV.
NOTE
Start, Pause, and Resume use the same button. The
function (Start, Pause or Resume) changes based upon the
status of MiroView™ RTV software.
CAUTION
MiroView™ RTV is not software for to be used for
diagnostic purposes. Use the MiroView™ software for
viewing the patient images for diagnostic purposes.
CAUTION
Do not disconnect the receiver while the RTV is in use. If
the receiver is disconnected during use, the software may
need to be restarted.
NOTE
If an error message appears while using MiroView™ RTV,
reconnect the USB cable between MiroCam® receiver and
UMPC