User's Manual
Using MiroView Software Chapter 4
4- 24
4.3.6 Image Data Upload
After the MiroCam® Capsule endoscopy procedure, upload the
image data from the MiroCam® Receiver to the MiroCam® system
via the 0LUR9LHZ Operator. Click the
to upload the image
data from the MiroCam® Receiver.
After the image data in the MiroCam® Receiver has been
successfully uploaded, enter the List Mode and check if the new
Case has been created.
- Double-click the
to run the 0LUR9LHZClient.
- Select the newly uploaded image data and enter the Review Mode.
- Play the case to check the uploaded image data.
CAUTION
If uploading of the image data failed, disconnect
the USB cable from the workstation, turn off the
MiroCam® Receiver and back on. Reconnect the
USB cable to the workstation and try uploading
once more. If the problem continues, please
contact the local IntroMedic distributor.
NOTE
0DNH VXUH WKH SDWLHQW¶V QDPH KDV EHHQ LQSXWWHG
properly prior to uploading the image data. If the
image data is uploaded with the wrong patient
name, it could result in misdiagnosis or delay in
diagnosis.
NOTE
If the user uploads an image data which has been
XSORDGHGEHIRUHDQHUURUPHVVDJHµ'DWDKDVEHHQ
previously uploaded. Would you like to upload
agDLQ"¶ZLOODSSHDU
NOTE
The user can stop the uploading of the image data
while uploading process file by clicking the
.