Invacare® TheraPure™ Recessed Whirlpool Tubs Model 3752G Model 3802G User Manual This manual MUST be given to the user of the product. BEFORE using this product, read this manual and save for future reference.
CONTENTS 1 GENERAL 4 Symbols and Signal Words................................................................................................................................................................................................................ 4 Limited Warranty ...............................................................................................................................................................................................................................
CONTENTS 5 OPERATING INSTRUCTIONS 20 Overview .............................................................................................................................................................................................................................................. 20 Cleaning and Disinfecting ...................................................................................................................................................................................................
1 GENERAL 1 General 1.1 Symbols and Signal Words Signal words are used in this manual and apply to hazards or unsafe practices which could result in personal injury or property damage. See the information below for definitions of the signal words. ! DANGER Danger indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING Warning indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
1 GENERAL 1.2 Limited Warranty PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975. This warranty is extended only to the original purchaser/user of our products. This warranty gives you specific legal rights and you may also have other legal rights which vary from state to state. Invacare Continuing Care, Inc.
2 SAFETY 2 Safety The Safety section contains important information for the safe operation and use of this product. 2.1 General Guidelines ! 2.2 WARNING DO NOT use this product or any available optional equipment without first completely reading and understanding these instructions and any additional instructional material such as owner’s manuals, service manuals or instruction sheets supplied with this product or optional equipment.
2 SAFETY WARNING - PLUMBING WARNINGS - SAFE USE Be certain all plumbing work is performed by a qualified plumber and is in compliance with local codes. WARNING - FLOOR LOAD CAPACITY The installation area MUST be able to support the 66 pounds per square inch (45 n/cm²) load capacity of the tub. Otherwise, injury or damage may occur. Use this unit only for its intended use as described in this manual. If any part of the system is not functioning properly, DO NOT use the tub.
3 OVERVIEW 3 Overview 3.1 Features Model 3802G Water Temperature Control Water Temperature Thermometer Whirlpool ON/OFF Button Fill Button (Push-in once to auto-fill, push-in and hold to add additional water to tub) Tub Fill Spout Overflow Shower/Massage ON/OFF Button Shower/Massage Wand Shower Spray Adjustment Flow Control Valve Adjustment for angle of wand in cradle Service Access Door Door Invacare® TheraPure™ Recessed Whirlpool Tubs 8 Part No.
3 OVERVIEW Model 3752G Water Temperature Thermometer Whirlpool ON/OFF Button Fill Button (Push-in once to auto-fill, push-in and hold to add additional water to tub) Shower/Massage Wand Flow Control Valve Water Temperature Control Overflow Tub Fill Spout Shower Spray Adjustment Shower/Massage ON/OFF Button Adjustment for angle of wand in cradle Service Access Door Door Part No.
3 OVERVIEW 3.2 Product Labeling Labels located inside the Service Access Door Label located on Interior Hardware Invacare® TheraPure™ Recessed Whirlpool Tubs 10 Part No.
3 OVERVIEW 3.
3 OVERVIEW 3.4 Minimum Floor Space and Clearance Requirements Models 3752G or 3802G 12’ 4’ 11-1/2” TUB LENGTH HOT AND COLD WATER STUBS, 115 VOLT PUMP HOOKUP THIS END 3752G OR 3802G RECESSED TUB 2’ 7-1/2” ALLOW FOR A 40” DOOR SWING 9’ 5” 36” Invacare® TheraPure™ Recessed Whirlpool Tubs 12 Part No.
3 OVERVIEW 3.5 Dimensions Models 3752G or 3802G 59.5” C H 17” 27” 34” 41-1/2” 31” 36” E 6-1/2” 18” CL 5-1/2” 47” 3/4” Cold water stub with recommended shut off valve D 2” Drain (floor drain recommended) E 115V AC, 60 Hz, 15 A Input H 3/4” Hot water stub with recommended shut off valve Allow for 40” door swing (60” for wheelchair or lift access) D 31-1/2” C 16” 21” 21” CH E 7” 8” ing or a wf o l l A Part No.
4 INSTALLATION 4 Installation WARNINGS CAUTIONS Check all parts for shipping damage. In case of damage, DO NOT use. Contact the carrier for further instruction. The installation area MUST be able to support the 66 pounds per square inch (45 n/cm²) load capacity of the tub. Otherwise, injury or damage might occur. Access for servicing the tub MUST be provided. Install the tub in a location that will permit access to the service panels, plumbing and electrical hookups.
4 INSTALLATION 4.1 Preparing the Work Area Access for servicing the tub MUST be provided. Follow the recommended floor plan. Refer to Minimum Floor Space and Clearance Requirements on page 12. The tubs are designed to be built-in against one, two or three walls, much the same way a traditional tub/shower unit is installed in an alcove. Optional end panels are available for corner or one wall installation and are only available at the time of the tub order. One wall installation 1. 2. 3. 4.
4 INSTALLATION 4.2 Electrical and Plumbing Hook-up Locations Refer to Electrical Installation on page 17 and Plumbing Installation on page 18. Model 3752G shown below.
4 INSTALLATION 4.3 Electrical Installation DANGERS - ELECTRICAL SHOCK HAZARD WARNINGS Grounding is required. The installation and maintenance of the tub MUST be done by a qualified technician, certified electrician or plumber. Disconnect electrical supply or turn off circuit breaker before installing or performing any maintenance on the tub. The National Electric Code requires the use of a ground fault circuit interrupter on all therapeutic pools and tubs (hydro therapeutic tanks).
4 INSTALLATION 4.4 Plumbing Installation DANGER - RISK OF SCALDING The hot water supply to the tub MUST NOT exceed 110° F (43° C) to protect the user from scalding. WARNINGS Be certain all plumbing work is performed by a qualified plumber and is in compliance with local codes. Some state and local plumbing codes require the installation of a “reduced pressure zone” (RPZ) assembly on both the incoming hot and cold supply lines to prevent back flow contamination into the potable water system.
4 INSTALLATION Check local codes regarding maximum water temperature allowed at hot water outlets for facility type. HOT In House Water Service COLD Optional Pressure Regulator Tub Spout Mixing Valve Shower Control Valve Tub Fill Valve Shower/Massage Wand Backflow Preventor (located inside tub cabinet) 4.5 Post Installation Checklist Before putting the tub into service, check the following: ❑ Water lines have been purged of any foreign matter.
5 OPERATING INSTRUCTIONS 5 Operating Instructions 5.1 Overview WARNINGS Read and understand ALL information in this manual BEFORE use. Clean and disinfect the tub after EACH use to avoid resident infection and contamination of the tub. DO NOT clean or disinfect the tub when it is occupied. Otherwise injury may occur. To reduce the risk of injury, DO NOT permit children or infirm persons to use this tub UNLESS THEY ARE SUPERVISED AT ALL TIMES.
5 OPERATING INSTRUCTIONS Perform these procedures in the following order: 1. Make sure that the tub has been cleaned, disinfected and BEFORE use. Refer to Cleaning and Disinfecting on page 21. 2. Open the tub door. 3. Transfer the resident to the tub. 4. Use the waist strap to help stabilize the resident in the tub as necessary. Refer to Waist Strap on page 27. 5. Fill the tub. 6. Bathe the resident. 7. Drain the tub. 8. Remove the waist strap (if used). 9. Open the door. 10.
5 OPERATING INSTRUCTIONS 1. 2. Use the drain plug to close the drain. Remove and disassemble all jet assemblies. Lay all pieces in the footwell of the tub. • Rotate each jet assembly counterclockwise and pull away from the jet casing. (Detail “A”). • Remove each impeller cap by rotating it clockwise (Detail “B”). • Remove each impeller (Detail “C”). Detail “B” Detail “A” Detail “C” Jet Casing Impeller Cap Impeller Impeller Jet Assembly 3. 4. 5. 6. 7.
5 OPERATING INSTRUCTIONS 8. Replace the impeller and impeller cap on each jet assembly. 9. WARNING Cross-threading the jet assembly onto the casing may cause damage to the whirlpool motor. After installation, ensure that the jet assembly is flush against the jet casing. Assemble each jet assembly to the jet casings. • Position the Sanijet® logo and RED indicator at the 11 o’clock position.
5 OPERATING INSTRUCTIONS Jet Casing Sanijet Logo Jet Assembly Removing Calcium Deposits, Scale and Lime Build-up Spray a commercially available cleaner (full strength) for the intended application on all surfaces to be cleaned. Allow the cleaner to remain in contact with surfaces for at least five minutes to as long as 12 hours. Rinse off surfaces using the shower wand, adjusted to the spray position. Use the cleaner according to the manufacturer's instructions.
5 OPERATING INSTRUCTIONS 5.3 Opening/Closing the Tub Door WARNINGS DO NOT open the door when water is in the tub, otherwise serious injury could result. DO NOT fill or use the tub if the door does not lock - otherwise serious injury or damage may occur Opening the Tub Door 1. Place one hand on top of the door handle. 2. Use the other hand to pull the safety pin out and release the door handle. 3. Lift up on the door handle and open the door. Closing the Tub Door 1. Close the door. 2.
5 OPERATING INSTRUCTIONS Door Handle Safety Pin Door Invacare® TheraPure™ Recessed Whirlpool Tubs 26 Part No.
5 OPERATING INSTRUCTIONS 5.4 Waist Strap The waist strap is a positioning guide only. The strap is not designed for use as a safety device or as a restraint. The strap MUST be washed and disinfected after each use. Refer to Cleaning and Disinfecting on page 21. Installation On each end of the waist strap, insert the lead into the round portion of the slot in the attachment point, slide the lead up and turn it. Use 1. 2. Bring both ends of the waist strap around the resident.
5 OPERATING INSTRUCTIONS 5.5 Water Temperature Setting WARNING The causes, symptoms and effects of hyperthermia may be described as follows: Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal body temperature of 98.6° F. The symptoms of hyperthermia include an increase in the internal temperature of the body, dizziness, lethargy, drowsiness, and fainting.
5 OPERATING INSTRUCTIONS 5.6 1. 2. Filling the Tub DANGER - RISK OF SCALDING WARNING Check that the water temperature is between 95° and 105°F (35°C and 41°C) to avoid scalding the resident. Monitor the incoming water temperature on the flow water thermometer. ALWAYS hand test the incoming water temperature and the water temperature in the tub. DO NOT stand in the tub. The tub surfaces are slippery when wet. Serious injury may occur. Close the drain with the blue stopper.
5 OPERATING INSTRUCTIONS Refer to the following chart for shower head adjustment settings. Stream 5.8 1. 2. 3. 4. 5. 6. Pulse Massage Shower Spray Mixture of Shower Spray and Pulse Massage Flow Control serves as a volume control and water saver. The use of the Flow Control permits the reduction of water flow without the need for readjustment of water temperature during bathing. A trickle of water through the Flow Control when in the closed position is normal.
6 INSPECTION AND TROUBLESHOOTING 6 Inspection and Troubleshooting If any part of the system is not functioning properly, DO NOT use the system. For parts and technical service information please contact ICCI Technical Service at (800) 668-2337, Extension 2. 6.1 Safety Inspection Checklists Every six months or as necessary have a qualified technician perform a thorough inspection and servicing. Routine maintenance will extend the life and efficiency of your tub.
6 INSPECTION AND TROUBLESHOOTING 6.2 Troubleshooting If problems are not remedied, contact technical support at 1-800-668-2337, Extension 2.
6 INSPECTION AND TROUBLESHOOTING 6.3 Maintenance Record \ DATE MAINTENANCE PERSON Part No.
NOTES Notes Invacare® TheraPure™ Recessed Whirlpool Tubs 34 Part No.
NOTES Notes Part No.
Invacare Corporation www.invacare-cc.com USA and Canada One Invacare Way Elyria, Ohio USA 44036-2125 Manufacturing Location © 2011 Invacare Corporation. All rights reserved. 899 Cleveland Street Republication, duplication or modification in whole Elyria, Ohio 44036 or in part is prohibited without prior written permission from Invacare. Trademarks are identified by ™ and ®. All trademarks are owned by or licensed to Invacare Corporation or its subsidiaries unless otherwise noted.
