True Low Air Loss System Owner's Operator and Maintenance Manual
Table Of Contents
- Special Notes
- Register Your Product
- Typical Product Parameters
- Label Location
- Section 1— General Guidelines
- Section 2— Operation
- Installing the Mattress Replacement System
- Installing the Side Rails
- Installing the Control Unit
- Connecting the Hose
- Connecting the Power Cord
- Using the Front Panel
- Powering Up the System
- Placing the Patient on the Mattress
- Transferring Patient From/To a Gurney
- Transferring Patient From/To a Wheelchair
- Preparing for CPR Procedure
- Section 3— Maintenance and Troubleshooting
- LIMITED WARRANTY
SECTION 2—OPERATION
MA80 Series 12 Part No 1148138
Connecting the Hose
CAUTION
Ensure that the hose connecting the control unit to the mattress is routed such that
it cannot be stepped on, kinked, squeezed or otherwise damaged.
NOTE: For this procedure, refer to FIGURE 2.3.
1. Locate the hose at the foot end of the mattress.
2. Locate the control unit connector on the right side of the control unit.
3. Lift and hold the connector cover up.
4. Push the hose connector (Detail “A”) onto the control connector.
5. Ensure the hose connector is flush with the control unit connector.
FIGURE 2.3 Connecting the Hose
Connector
Cover
Control Unit
Connector
Holes
Hose
Connector
DETAIL “A”
Control
Unit