True Low Air Loss System Owner's Operator and Maintenance Manual
Table Of Contents
- Special Notes
- Register Your Product
- Typical Product Parameters
- Label Location
- Section 1— General Guidelines
- Section 2— Operation
- Installing the Mattress Replacement System
- Installing the Side Rails
- Installing the Control Unit
- Connecting the Hose
- Connecting the Power Cord
- Using the Front Panel
- Powering Up the System
- Placing the Patient on the Mattress
- Transferring Patient From/To a Gurney
- Transferring Patient From/To a Wheelchair
- Preparing for CPR Procedure
- Section 3— Maintenance and Troubleshooting
- LIMITED WARRANTY
LABEL LOCATION
Part No 1148138 7 MA80 Series
LABEL LOCATION
DANGER-EXPLOSION HAZARD: DO NOT use in the presence of
flammable anesthetics.
CAUTION: Equipment should be connected to a properly grounded
receptacle (3-prong). Risk of Electrical shock. DO NOT remove
back. Disconnect air hose before administering CPR.
NOTE: This label is on the back of
the unit and also contains the
serial number.
WARNING
Patient entrapment with bed side rails may cause injury or death. Mattress
MUST fit bed frame and side rails snugly to prevent patient entrapment.
Follow the manufacturer’s instructions. Monitor patient frequently. Read
and understand the Owner’s/Operator’s Manual prior to using this
equipment. Invacare product manuals are available at www.invacare.com
or your dealer.
Label part number 1150708 Rev A
ATTENTION
Clean Filter Every 5 months and
Whenever Dirty. Remove Filter,
Wash, Dry & Replace.