Power Wheelchair Owner's Operator and Maintenance Manual

SECTION 6—RIDING POSITION
Recumbent Handcycle Series 34 Part No 1114850
Adjusting Hand Crank
 WARNING
DO NOT operate the handcycle if the hand crank obstructs your view. If the hand
crank obstructs your view, adjust the height before using the handcycle - otherwise
injury or damage may occur.
Adjusting Hand Crank Height - All Models Except Top End XLT Gold
NOTE:Forthisprocedure,refertoFIGURE 6.4.
1. Loosen,butDONOTremovethetwo
setscrewssecuringthehandcrankto
theforkstem.
2. Movethehandcrankassemblyupor
downontheforkstemuntilyouare
comfortablewiththepositionfor
operationalpurposes.
NOTE:Thehandcrankshouldbepositionedso
thatwhenthehandistowardthefrontofthe
handcycle,thearmisslightlybent.Thearm
shouldNEVERbefullyextended(locked)at
anypointwhilecranking.
FIGURE 6.4 Adjusting Hand Crank Height -
All Models Except Top End XLT Gold
3. Tightenthehexnuttosecurethehandcrankinthedesiredposition.
4. Tightenthechainifnecessary.RefertoAdjustingTwenty‐SevenSpeedCassetteChain
onpage 56.
Set Screws
Fork Stem
Hand Crank