Power Wheelchair Owner's Operator and Maintenance Manual

SECTION 6—RIDING POSITION
Recumbent Handcycle Series 36 Part No 1114850
Adjusting Seat Fore/Aft - All Models Except XLT Gold
and Top End Force
NOTE:Forthisprocedure,refertoFIGURE 6.6.
NOTE:Seatshouldbeadjustedsothatwhenseatedwithfeetinthefootrests,thereisaslightbend
atthekneeandaslightbendattheelbowwhenthehandcrankisfurthestaway.
1. Ifinstalled,activateparkingbrake.
2. Loosen,butDONOTremovethefourrearsocketscrewsthatsecuretherearseat
frametothehandcycleframe.
3. Loosen,butDONOTremovethetwofrontsocketscrewsthatsecurethefrontofthe
seatframetothehandcycleframe.
NOTE:Therearesocketscrewsontherightandleftsideofthehandcycle.
4. Loosen,butDONOTremovethehexboltsandlocknutsthatsecurethetwoseatangle
adjustmentclampstotherearseatsupports.
NOTE:Thereisoneclampontherightandleftsideofthehandcycle.
5. Performoneofthefollowing:
•MovingtheSeatRearward‐Whileliftinguponthebacksupporttubes,pushthe
seatrearwardtothedesiredposition.
•MovingtheSeatForward‐Whilepushingdownonthebacksupporttubes,pull
theseatforwardtothedesiredposition.
6. Tightenthesixsocketscrewsthatsecuretheseatframetothehandcycleframe
securely.
7. Tightenthehexboltsandlocknutsthatsecurethetwoseatangleadjustmentclamps
totherearseatsupportssecurely.
FIGURE 6.6 Adjusting Seat Fore/Aft - All Models Except XLT Gold and Top End Force
Seat Angle
Adjustment
Clamps
Back Support Tube
Seat Frame
Front Socket Screw
Height Adjustment Bracket
Rear Socket Screws
Handcycle
Frame
Height Adjustment Clamp