Power Wheelchair Owner's Operator and Maintenance Manual

SECTION 7—WHEELS
Recumbent Handcycle Series 42 Part No 1114850
SECTION 7—WHEELS
 WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Installing/Adjusting the Rear Wheel and Quick-Release
Axles
NOTE:Forthisprocedure,refertoFIGURE 7.1.
1. Makesurethattheaxlereceiverhexnut
issecurelytightenedbeforeinstalling
therearwheels.
2. Depressdetentpininthequick‐release
axleandslideaxlethroughtheaxle
receiver.
3. Releasedetentpinensuringthatthe
lockingpinsarefullyreleased.
NOTE:LockingpinsMUSTprotrudepastthe
endoftheaxlereceivertofullyrelease.Any
excessiveplayMUSTalsobeeliminated.
FIGURE 7.1 Installing/Adjusting the Rear
Wheel and Quick-Release Axles
4. Increaseordecreaseendplaybyadjustingthelocknutontheendofthequick‐release
axle.
 WARNING
Make sure detent pin is fully released before operating the handcycle.
Keep locking pins clean.
5. Reinstallrearwheelonthehandcycle.
6. Tilthandcycleontoeitherrearwheelandspinraisedwheel.Itshouldspinfreelywith
noexcessivedrag.
7. Repeatprocedureforoppositerearwheel.
NOTE:Ifdragtoeithersideoccurs,repeattheprocedureuntilthehandcyclerollscorrectly.
Axle Receiver
Hex Nut
Quick-release
Axle
Locknut
Locking
Pins
Axle Receiver
Detent
Pin