Power Wheelchair Owner's Operator and Maintenance Manual

SECTION 8—SERVICE PROCEDURES
Part No 1114850 53 Recumbent Handcycle Series
FIGURE 8.4 Installing/Removing/Adjusting the Steering Dampener - For Top End XLT Gold
and Force Only
Installing Seven Speed Shifter Cable
NOTE:Forthisprocedure,refertoFIGURE 8.5.
NOTE:ThisprocedureappliestotheTopEndXLTonly.
NOTE:ThesevenspeedShifterCableruns
fromtherightsideofthefrontframetoits
mountingpositiononthehandcrankassembly.
1. Runthecablefromtheright‐sideofthe
forkassemblytomountingpositionon
theleftsidejustbelowthehandcrank
assembly.
2. Attachthesevenspeedshiftertothe
handcrankassemblyextension.
3. Securewithhardwareprovided.
FIGURE 8.5 Installing Seven Speed Shifter
Cable
Steering
Dampener
Socket Screws
(One Located on Both Sides
of the Handcycle Frame)
Dampener
Clamp (Tab)
Lower
Threaded
Post and
Locknut
Upper Threaded Post and Locknut
Handcycle
Frame
Crank
Assembly Tab
Dampener
Clamp (Tab)
Handcycle
Frame
Upper Threaded
Post and Locknut
Crank
Assembly Tab
Steering
Dampener
Top End
Force
ONLY
Top End
XLT Gold
ONLY
Hand Crank
Assembly
Extension
Shifter
Cable