Power Wheelchair Owner's Operator and Maintenance Manual

SECTION 9—OPTIONS
Part No 1114850 65 Recumbent Handcycle Series
2. Firmlytightenthebolt.
NOTE:Handleshouldspinfreelywithminimalplay.Ifhandledoesnotspinfreelymakesur ethe
spacerisfirmlyinplace.Ifhandlestilldoesnotspinfreely,contactInvacare.
FIGURE 9.10 Installing V/S Crankarm Handles - For Models Made Before 7/12/07
For Models Made After 7/12/07
 WARNING
Failure to install handle assembly
properly could result in injury.
It is recommended to inspect this
assembly prior to and after each use.
NOTE:Forthisprocedure,referto
FIGURE 9.11.
1. Securethehandletothecrankarm
housingusingthesetscrewand
locknut.
NOTE:Usetherighthandle,thehandlewitha
mountingpost,withtherightcrankarmand
leftwithleftcrankarm.Therightcrankarmhas
aflangeatthebaseofthecrankarm.Theleft
crankarmdoesnot.
2. Firmlytightenthelocknut.
NOTE:Handleshouldspinfreelywith
minimalplay.Ifhandledoesnotspinfreely,
contactInvacare.
FIGURE 9.11 Installing V/S Crankarm
Handles - For Models Made After 7/12/07
Crankarm
Handle
Bearing
Spacer
Bolt
Bearing
Crankarm
Housing
Crankarm
Handle
Locknut
Left
Crankarm
Flange
Right
Crankarm
DETAIL “A” - HANDLE
REPLACEMENT
Crankarm Housing
Set
Screw
DETAIL “B” - CRANKARM
ORIENTATION
Left
Handle
Right
Handle
Mounting
Post