Power Wheelchair Owner's Operator and Maintenance Manual

SECTION 9—OPTIONS
Part No 1114850 69 Recumbent Handcycle Series
FIGURE 9.15 Removing/Installing the Fork - Travel Ready XLT PRO Equipped with Road
Crown Compensator
Removing/Installing the Fork - XLT Gold, and Top End
Force Equipped with Steering Dampener
NOTE:Forthisprocedure,refertoFIGURE 9.16onpage70.
Removing the Fork
1. Removethelocknutsecuringthesteeringdampenertothedampenerclamp
(DetailʺAʺ).
2. Removethetwosocketscrewssecuringthedampenerclamptothehandcycleframe.
3. Removethedampenerclampfromthehandcycleframeandthelowerthreadedpost
ofthesteeringdampener.
4. Removethetwosocketscrewsfromthefork
clamp.
5. Removetheplatefromthetopofthefork.
6. Removetheforkfromtheframe.
7. Removethefrontwheelfromthefork.RefertoRemovingtheFrontWheel
onpage 70.
Installing the Fork
1. Positiontheforkontotheframe.
2. Positiontheplateontothefork.
Fork Clamp
Plate
Socket
Screws
Fork
Fork
Clamps
Nut
Fork Bolt
Road Crown Compensator
Frame
Fork
Clamp